电子自旋共振准三维图象的重建方法

根据投影切片原理, 设计了一个简单而有效的ESR图象重建算法和程序, 可利用样品的一集ESR谱, 方便地绘制出样品在某截面的自旋密度立体轮廓图、等值图和散点密度分布图等, 为分析和研究自旋密度的分布及其性质, 提供了直观依据。作为应用, 文中给出了石英杜瓦受紫外光辐照后产生的局部晶格缺陷——F心的空间分布图, 图中清楚表明, F心的浓度与辐照方向和辐照强度的密切关系, 与试验结果完全相符。     

铜表面腐蚀的激光扫描微区光电压图象的研究

铜表面腐蚀的激光扫描微区光电压图象的研究杨迈之，张雯，蔡生民，任聚杰（北京大学化学系，北京，１０００７１）（河北医学院化学系，石家庄）潘传智，杨勇（浙江工业大学化工系，杭州）（厦门大学化学系，厦门）关键词铜，缓蚀剂，微区光电压图铜的腐蚀与防腐早已引起...     

Tumor cell detection method using complement-mediated cytolytic reaction and imaging sensor system

A novel tumor-detection system consisting of complementmediated cytolytic reaction and an image processing system was developed for the simple and rapid determination of tumor cells. The present system consists of a CCD image sensor, image memory board, personal computer, and microscope. When monoclonal antibody 3C4, which is specific to the guinea pig hepatoma L-10, was added to cell suspension, only L-10 cytolysis occurred. Cytolysis caused a decrease in brightness of the cells observed by phase-contrast microscopy. The phase contrast image of the cells before cytolysis was converted to a digitalized signal and stored in computer memory. After cytolysis, a brightness threshold above that of lysed cells was subtracted from the digitalized signal and compared to the signal stored before reaction. L-10 cells in mixed cell suspension were determined specifically by the system. Measurement time was only 2 sec and overall time, including reaction time, was approximately 30 min. Since this method does not require a cell washing process, automation of the whole system is possible.     

太阳CO 4.6微米红外成像观测

太阳红外光谱中蕴含着丰富的物理信息,其中CO 4.6μm波段是具有代表性的分子谱带,其形成于温度极小区附近,对研究太阳物理具有极其重要的意义。为获得CO 4.6μm波段太阳单色像,本文建立了一套全反射太阳红外成像观测系统。该系统采用定天镜跟踪引光,通过成像反射镜将太阳成像于3~5μm波段红外相机的焦平面上,该相机采用的是国产HgCdTe焦平面阵列器件。同时,为提高信噪比,提出了一种有效计算平场提取观测目标的方法,并利用该方法获得了CO 4.6μm波段的太阳单色像。     

Syntheses of Two Potential Ligands for Tc-99m Labeling as Diagnosis Agents of Alzheimer''''s Disease

Two types of ligands-biphenyl and stilbene derivatives, whichcan be labeled with Tc-99m for the diagnosis of Alzheimer'sdisease (AD) have been synthesized successfully. The key stepsin these two syntheses involved Suzuki reaction and Wittig reac-tion respectively. The new discovered debromination reactionmay be expanded to the compounds with double or triple bondadjacent to the carbon atom bearing the bromine atoms. Thesetypes of syntheses provide a route to a series of biphenyl andstilbene derivatives that will benefit the search of new imagingagents for AD.     

Quantitative surface analysis by Auger and x-ray photoelectron spectroscopy

Recent developments in quantitative surface analysis by Auger (AES) and x-ray photoelectron (XPS) spectroscopies are reviewed and problems relating to a more accurate quantitative interpretation of AES/XPS experimental data are discussed. Special attention is paid to consideration of elementary physical processes involved and influence of multiple scattering effects on signal line intensities. In particular, the major features of core-shell ionization by electron impact, Auger transitions and photoionization are considered qualitatively and rigorous approaches used to calculate the respective transition probabilities are analysed. It is shown that, in amorphous and polycrystalline targets, incoherent scattering of primary and signal Auger and photoelectrons can be described by solving analytically a kinetic equation with appropriate boundary conditions. The analytical results for the angular and energy distribution, the mean escape depth, and the escape probability as a function of depth of origin of signal electrons as well as that for the backscattering factor in AES are in good agreement with the corresponding Mote Carlo simulation data. Methods for inelastic background subtraction, surface composition determination and depth-profile reconstructions by angle-resolved AES/XPS are discussed. Examples of novel techniques based on x-ray induced photoemission are considered.     

Electromagnetic interference shielding and radiation absorption in thin polypyrrole films

Results of permittivity measurements, electromagnetic interference shielding effectiveness, and heat generation due to microwave absorption in conducting polymer coated textiles are reported and discussed. The intrinsically conducting polymer, polypyrrole, doped with anthraquinone-2-sulfonic acid (AQSA) or para-toluene-2-sulfonic acid (pTSA) was applied on textile substrates and the resulting materials were investigated in the frequency range 1-18 GHz. The 0.54 mm thick conducting textile/polypyrrole composites absorbed up to 49.5% of the incident 30-35 W microwave radiation. A thermography station was used to monitor the temperature of these composites during the irradiation process, where absorption was confirmed via visible heat losses. Samples with lower conductivity showed larger temperature increases caused by microwave absorption compared to samples with higher conductivity. A sample with an average sheet resistivity of 150 Ω/sq. showed a maximum temperature increase of 5.27 °C, whilst a sample with a lower resistivity (105 Ω/sq.) rose by 3.85 °C.     

Characterization of CNS disorders and evaluation of therapy using structural and functional MRI

Modern drug development requires technologies that allow rapid translation from the preclinical to the clinical stage. It is obvious that non-invasive imaging modalities such as magnetic resonance imaging (MRI) will play a central role in this regard. This article reviews the use of structural and functional MRI readouts for characterization of central nervous system (CNS) disorders and evaluation of the efficacy of potential CNS drugs. Examples comprise dementia of Alzheimer's type, cerebral ischemia, and neuroinflammation covering both clinical and preclinical aspects. In these examples MRI has been used to obtain relevant structural information on brain atrophy, on the location and extent of ischemic brain areas, and on the number and distribution of demyelinated plaques. These structural data are complemented by readouts assessing the functional consequences associated with the pathomorphological changes. In the last decade, MRI has evolved into a standard tool for the development of CNS drugs. With regard to target-specific/molecular imaging applications MRI is limited by its inherently low sensitivity; complementary imaging modalities utilizing optical and radionuclear reporter systems will thus be required.     

成像技术在食品安全与质量控制中的研究进展

食品质量与安全是政府、食品行业以及消费者十分关注的问题。为了保证食品质量与安全，需要对食品中的风险因子进行检测。传统的分析方法如生物化学方法和仪器分析方法（色谱法、色谱-质谱法）存在前处理比较复杂，耗时，对样品具有破坏性及无法获取目标物空间信息等缺点。因此，开发快速，无损，实时和可视化的检测技术十分重要，这也是食品领域研究的热点。近年来，高光谱成像技术融合了成像和光谱两种技术，可以作为一种用于食品质量和安全评估的非破坏性和实时检测的工具。拉曼光谱成像技术可以同时获得待测物的光谱和空间信息，具有快速，无损和低成本等优点，在食品安全评价和质量控制中也得到了成功应用。质谱成像技术不需要标记和染色，即可实现样品组织表面待测物的可视化和高通量分析。它作为一种分子可视化技术，可以获得食品中营养成分及内、外源性有害物质的空间分布信息，在食品领域也表现出良好的应用前景。本文检索了近几年国内外发表的成像技术在食品研究中的相关文献，介绍了高光谱成像技术、拉曼光谱成像技术和质谱成像技术的原理，并综述了它们在食品安全与质量控制中的应用。此外，本文分析和讨论了这几种成像技术的优缺点，并对成像技术在食品领域的发展前景做出了展望。     

The characteristic fragment ions and visualization of cationic starches on pulp fiber using ToF‐SIMS

Time‐of‐flight secondary ion mass spectrometry (ToF‐SIMS) was used to investigate the distribution of cationic starch on pulp fiber. To identify the characteristic fragment ions of the cationic starches, deuterium‐labeled cationic starches were prepared and analyzed using ToF‐SIMS. The starch 2‐hydroxypropyltrimethylammonium chloride derivative generated characteristic fragments at m/z 58 and 59, which were identified as [H₂C?N(CH₃)₂]⁺ and [N(CH₃)₃]^+·, respectively. The fragmentation patterns were also suggested. From the imaging analysis, the adsorption of the cationic starch on fibers was uneven on individual fibers, as well as between fibers. This may have been on account of fiber morphology and structure. On examining scanning electron microscope (SEM) images, the quaternary ammonium starch derivative (QS) did not penetrate the fiber. No migration of cationic starch was observed under various drying conditions. Copyright © 2007 John Wiley & Sons, Ltd.